您的位置: 嵌入式在线 > 解决方案 > 商业金融 > NXP TDA8023低功耗IC卡接口方案

NXP TDA8023低功耗IC卡接口方案

2008-01-30      嵌入式在线      收藏 | 打印

        NXP 公司的TDA8023是完整的低功耗同步或异步智能 IC卡模拟接口芯片。它用在卡和微控制器之间,用很少的外接元件就能提供电源,保护和控制功能,广泛用在银行终端,互联网终端,机顶盒和手提IC卡阅读器。

      本文介绍TDA8023主要性能,方框图以及典型应用电路图。

        The TDA8023 is a complete cost-efficient, low-power analog interface for synchronous or asynchronous smart cards. It can be placed between the card and the microcontroller wit very few external components to perform all supply, protection and control functions.

        主要性能: 
        I2C-bus controlled IC card interface in TSSOP28
        Supply voltage from 2.7 V to 6.5 V
        Independant supply voltage VDD(INTF) for interface signals with the microcontroller
        Shutdown input for very low power consumption when the part is not used
        Power reduction modes when the card is active
        DC-to-DC converter for VCC generation (capacitive doubler, tripler, or inductive, or
        follower automatically selected according to supply voltage and card voltage)
        1 specific protected half duplex bidirectional buffered I/O line, with current limitation at
        15 mA, maximum frequency 1 MHz
        2 auxiliary card I/O lines controlled by I2C-bus (C4 and C8)
        VCC regulation: 5 V, 3 V or 1.8 V &#61617;&#61472;8 %, ICC < 55 mA, current spikes of 40 nAs up to
        20 MHz, with controlled rise and fall times, filtered overload detection approximately
        80 mA, current limitation about 120 mA
        Thermal and short-circuit protections on all card contacts
        Automatic activation and deactivation sequences: initiated by software or by hardware
in the event of a short-circuit, card take-off, overheating, VDD or VDD(DCDC) drop-out
        Enhanced ElectroStatic Discharge (ESD) protection on card side (> 6 kV)
        20 MHz clock input
        Clock generation for the card up to 10 MHz (CLKIN divided by 1, 2, 4 or 5) with
        synchronous frequency changes; stop HIGH or LOW or free running 1 MHz in cards
        Low-power mode; current limitation on pin CLK (C3)
        RST signal (C2) with current limitation at 20 mA, controlled by an embedded
        programmable CLK pulse counter on asynchronous cards or by a register on
        synchronous cards
        ISO 7816-3, GSM 11.11 and EMV 2000 (payment systems) compatibility
        Supply voltage supervisor for spike killing during power-on and emergency         deactivation at power-off: threshold internally fixed or set via an external resistor bridge; pulse width internally fixed or set via an external capacitor
        Card presence input with 10 ms built-in debouncing system
        One interrupt signal INT

       应用:
      Banking terminals
      Internet terminals
      Set-top boxes
      Portable IC card readers

图1。带容性DC/DC转换器的 TDA8023方框图



图2带感性DC/DC转换器的 TDA8023方框图




图3带容性DC/DC转换器的 TDA8023 TT应用电路图

本文来源:NXP     作者:

隐藏原文↑


查看原文↓

IC卡 相关产品动态
解决方案悬赏

如果您是正在寻求此类产品解决方案的整机制造商,请点击”我要悬赏”按钮提交您所需要的特定解决方案。

我要悬赏
解决方案揭榜

如果您是此类产品解决方案的提供商、组织或个人,请点击“我要揭榜”按钮揭榜悬赏区里您所拥有的解决方案。

我要揭榜

验证码:  看不清?